Mount these Good Hand Toggle Clamps on this low-profile, pre-tapped Adjustable Mounting Base.
The thickness of the Aluminum base adds 5/8″ to the maximum capacity of the Toggle Clamp.
Use ...
Place the Inserta Clamps into the 5/8″ holes on the BuildPro tabletop and squares for fast, easy clamping. Clamp in the vertical or horizontal position at any height.
The Ratchet Handle Model is id...
The 360º Sliding Channel Clamp slides into the 1.7″ spacing between plates which enables the clamp body to slide along the entire surface and swivel 360º for positioning at any point.
* Not appl...
Place the Adjustable T-Post Clamp in any of the Ø5/8″ holes on the BuildPro Tabletop or Heavy Duty Riser Blocks for vertical hold-down clamping.
Use the versatile Pivoting model to apply a...
Mount Toggle Clamps directly on the BuildPro Tabletop, Riser Blocks or Econo Stop & Clamping Squares, for the height and reach required for each hold-down application.
* A low-profile,...
Insert into the Buildpro table holes for low profile, light duty, horizontal clamping.
A turn of the aluminum knob advances the spindle, bringing the swivel foot to rest against the face of your st...
The side push clamp is designed for applying lateral pressure with a slight down force to keep the workpiece from lifting or rolling upwards.
Extra long spindle insures you can reach anywh...
Mount on the Right Angle Bracket, Riser Block, or Clamping Squares for push down clamping at an elevated height for taller workpieces. The patented rear crank handle allows clamp pressure adjustmen...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
